TreasureGirl
Nov 19 2007, 12:50 AM
How well do these screwdowns protect pre-1965 proof sets? I'm asking for a set with silver in it for Christmas but I don't know if the screwdowns work well enough or if I should re-package them myself. Thoughts?
Thanks,
TG
bill
Nov 19 2007, 06:28 AM
I'm assuming you are talking about Capital Plastics lucite holders? I have always like them myself. They look good, the provide a good degree of protection (from finger prints. scuffs, and the like. They are not air tight, but the coins can be easily removed unlike slabs. (Obviously I have a distaste for slabs.)
Scottishmoney
Nov 19 2007, 11:31 AM
At the age of the plastics that the original coins were packaged in, they would probably be better in the screwdowns than otherwise. I would just make sure you have the screws in tight and not loose.
TreasureGirl
Nov 19 2007, 04:46 PM
I apologize for not being more specific: you're saying that these

are better than these

Right? If so, that's what I needed to know! Thanks!
sbvenman
Nov 19 2007, 05:09 PM
So then, where do you put the mint token...
corkykile
Nov 19 2007, 06:42 PM
Hi Treasure,
With all the packets and clads and proofs I have opened lately, I think the cellophane wrappers are the worse.
Yes, I have been very naughty and gotten myself sets of Dansco albums with proof and silver proof holes, and have been using one of each uncirc, clad and proof sets I have to fill these albums.
So far the older sets, i.e., the 60's era in the hard plastic style holders have been the better preserved. And, as far as my money is concerned, the best quality minted coins of any others I have purchased. Most of them have been almost as perfect as they could possibly be. With that said, I have seen a couple of sets in the hard plastic holders at the coin shop that have discoloration. So one does need to search them carefully.
I hope you get more than one set for Christmas!
Corky
corkykile
Nov 19 2007, 06:43 PM
P.S.
The mint token goes still sealed into the drawer with all the others I have.
Corky
Scottishmoney
Nov 19 2007, 06:52 PM
The problem with the cellophane in these sets is that it was brittle, often splits or separates and is porous, where as with the screwdowns they are not near as porous and much more airtight as a result.
moneydog
Nov 19 2007, 08:08 PM
If you want them airtight just run a small bead of silicon around the edge. And with your finger smooth it down and into the edge of holder.
Brett
Nov 19 2007, 11:38 PM
Will silicon release any type of gas that may effect the coins???
Mark Stilson
Nov 20 2007, 12:18 AM
QUOTE(Brett @ Nov 19 2007, 05:38 PM)

Will silicon release any type of gas that may effect the coins???
RTV silicone does have an acid in it. If you put rtv on galvanized metal it will rust where it made contact. But I don't know if it would gas off and affect the metals in coins.
Mark Stilson
Nov 20 2007, 12:19 AM
QUOTE(Brett @ Nov 19 2007, 05:38 PM)

Will silicon release any type of gas that may effect the coins???
Edit: Sorry about a double post. It looked like the post did not make it at first.
moneydog
Nov 20 2007, 01:05 AM
I don't know if it will or not it was just a thought there is also some clear type of tape that might work. There is also different types of adhesive that might work better than silicone.
Scottishmoney
Nov 20 2007, 01:59 AM
All tapes like that will have glue, which has chemicals, which might and probably will cause reactions.
GDJMSP
Nov 20 2007, 03:41 AM
QUOTE(TreasureGirl @ Nov 19 2007, 10:46 AM)

I apologize for not being more specific: you're saying that these

are better than these

Right? If so, that's what I needed to know! Thanks!
Well there is something else that you should consider here. If you ever think of selling your Proof sets, I absolutely guarantee that they will bring higher prices in the original packaging than they will if they are in Captial holders. So by placing them in the Capital holders you could lose a significant percentage of value.
TreasureGirl
Nov 20 2007, 03:52 AM
Yes, I was worried about that, too... how much exactly would I lose on, say, a 1964 set?
moneydog
Nov 20 2007, 01:52 PM
QUOTE
All tapes like that will have glue, which has chemicals, which might and probably will cause reactions.
I never thought about the type but your right I would just leave them alone.
Well one other idea hit what whould a freezer bag do the small ones or large they are airtight.
LostDutchman
Nov 20 2007, 02:14 PM
I prefer them in the capital holders... but the big big dealers who buy them from me want original packaging...for common sets like 64's they pay half of bid if its not in the original packaging..
TreasureGirl
Nov 20 2007, 04:30 PM
So... buy in the Capital Holders to begin with?
LostDutchman
Nov 20 2007, 04:58 PM
good luck finding them at that price.... but thats what they are worth to the big dealers
GDJMSP
Nov 20 2007, 06:16 PM
QUOTE(TreasureGirl @ Nov 20 2007, 09:30 AM)

So... buy in the Capital Holders to begin with?
Usually you are better off to collect Proof sets in original packaging. When selling the sets, most dealers ask about the same price for orignal sets as they do those sets in the holders. But when buying them, most dealers will offer about half what they will for original sets. Doesn't seem right I know, but that is how it is.
So if you are going to buy them you may as well buy original sets.
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please
click here.